Sub-zero PRO 48 Manuale Utente Scaricare il pdf (Pagina 11)

11

PLUMBING REQUIREMENTS

The PRO 48 has an automatic ice maker. This

s

ystem operates on water pressure between

1.4 bar and 8.3 bar.

R

ough in the cold water supply line using

6,35 mm OD copper line. The water line should

be routed up through the floor within 13 mm

f

rom the back wall and no higher than 76 mm

off the floor. If you have to come through the

wall, make sure the water line is no more than

76 mm from the floor.

Regardless of the routing, allow .9 m of excess

copper tubing to remain outside the wall or

floor for easy connection to the unit. Locate

the water supply line within the shaded area

indicated in the Installation Specifications illus-

tration on the previous page.

Use an easily accessible shut-off valve

between the water supply and the unit. Do not

use self-piercing valves. A saddle valve kit

(part #4200880) is available from your

Sub-Zero dealer.

It is not recommended that the ice maker be

connected to a softened water supply. Water

softener chemicals, such as salt from a

malfunctioning softener, can damage the ice

maker and lead to poor ice quality. If a

softened water supply cannot be avoided, be

sure that the water softener is well maintained

and operating properly.

IMPOR

T

ANT NOTE:

Do not use with water

that is microbiologically unsafe or of unknown

water quality without adequate disinfection

before or after the system. Systems certified

for cyst reduction may be used on disinfected

waters that may contain filterable cysts.

MPOR

T

ANT NOTE:

All installations must

meet local plumbing code requirements.

IMPORTANT NOTE:

A reverse osmosis

system can be used, provided there is constant

water pressure of 1.4 bar to 8.3 bar supplied to

the unit at all times.

PRO 48 INSTALLATION INSTRUCTIONS

U

NPACKING THE

P

RO 48

U

ncrate the unit and inspect for any damages.

Remove the wood base and discard the

shipping bolts and brackets that hold the wood

b

ase to the bottom of the unit. Tip the unit

slightly to each side to remove styrene pads

under the base. Remove and discard all

p

acking materials.

IMPORTANT NOTE:

Do not discard the kick-

plate, anti-tip bracket and hardware or corner

protectors. These items will be needed for

installation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Commenti su questo manuale

Nessun commento