Sub-zero PRO 48 Manuale Utente Scaricare il pdf (Pagina 14)

CONCRETE FLOOR APPLICATIONS

Use the three 10 x 95,25 mm concrete wedge

anchors, six #12 x 63,5 mm wood screws and

s

ix #12 flat washers provided. Be sure that the

anchors and screws hold tight. Refer to the

illustration below.

IMPORTANT NOTE:

If the wood screws do not

hit a wall stud in any of the upper holes on the

anti-tip bracket, use the provided #8–18 x

31,75 mm wood screw, #12 flat washer and

nylon zip-it wall anchor in its place.

IMPORTANT NOTE:

In some installations the

subflooring or finished floor may necessitate

angling the wood screws used to fasten the

anti-tip bracket to the back wall. Refer to the

illustration below.

14

ANTI-TIP BRACKET

INSTALLATION

INSTALL CONCRETE WEDGE ANCHORS

1

)

D

rill a 10 mm diameter hole any depth

exceeding the minimum embedment. Clean

the hole or continue drilling additional

d

epth to accommodate drill fines. Use a

carbide drill bit.

2)

Assemble the washer and nut flush with the

end of anchor to protect threads. Drive the

anchor through the material to be fastened

until the washer is flush with the surface

material.

3)

Expand the anchor by tightening the nut

3–5 turns past hand-tight position or to 25

foot-pounds of torque.

Always wear safety glasses and use other

necessary protective devices or apparel

when installing or working with anchors.

Anchors are not recommended for use in

lightweight masonry material such as

block or brick, or for use in new concrete

which has not had sufficient time to cure.

The use of core drills is not recommended

to drill holes for the anchors.

Concrete floors

Make sure that there are no electrical

wires or plumbing in the area which the

screws could penetrate.

PRO 48 INSTALLATION INSTRUCTIONS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Commenti su questo manuale

Nessun commento